The applications and uses of this small light are limited only by
one's imagination.
The MicroStar TM consists of a super
bright white LED and circuit, potted in epoxy
within a 316 stainless steel housing. It is waterproof and runs
on 12 Volts DC.

Landscape applications
Because of the small current requirements and low voltage, one circuit,
either switched
by timer, photo cell or manually, can incorporate lights placed
in railings, landscape areas
and building exterior perimeter. A "full moon" illumination can
be provided to any desired area.
There are no blinding "hot spots" as occur with conventional lighting.
A typical house and
garden could be covered with 20 - 30 MicroStars TM
with a total power consumption of
under 10 watts!
3 in a rock, 20 feet under water
1" stainless tubing
Embedded in teak molding
Mounted in a wedge washer and snap-loc flex
Mounted on the side of a dome light: See page on Rage
for marine applications

Loose rock retaining wall and landscape application

Daytime shot of table top fountain; incredible illumination of water
at night
(lights embedded in rocks)
Battery powered emergency lighting
MicroStar TM mounted at an angle in sheet rock.
A simple battery back up system can be installed in home or office
that will come on
automatically in the event of a power outage.
With minimal current requirements, days of emergency lighting would
be available off a
small battery. Unlike other lights, there is no heat generated from
LEDs so placement can be
in ceilings or walls or plastic molding.
Patent pending on Suncor MicroStar TM