RAMP PLANS

Below are some of my idea's to build ramp for skateboarding and inline skating and bmx biking.


This first ramp can be used by in line skating.

First what you want to do is find a pices of wood that is flat and is around 24 inches then you have to find a curved pieces of wood that is goes to about 70 degrees then you'll need 2 pieces of wood that are flat so that the bottom pices of wood would conect to the top pices of wood and you'll need some one helping by holding the other pices of wood and you'll also need 4 nails or screws and a hammer or a screw driver then your readdy to start buliding yourself your own ramp now you take the flat pice of wood lay if on the floor then you take the curved piece of wood and put on top and make sure the curved wood is facing up and take the two pices of wood and put it behind the curved wood and make the bottom of the pieces are toching the flat peice of wood and nail them together then you got your self a ramp.


this ramp is for bmx biking and inline skating and skateboarding

first what you'll need is two flat pieces of wood that is around 24 inches and two stroungh small pieces of wood that is around 12-6inches and you'll have to have both of the two small pieces cut at the top at a 110 degree angle and you'll need 6 nails and a hammer and maybe some one else helping you first you want to start by is to take by laying on of the flat pieces of wood in the floor and hammer both the two small stick on to it make sure the small sticks are at that edge and they are straight also that the bottom of the stick is on it not the 110 degree part of the wood is not on it and then put the top and make sure it fit's perfectlyand hamher those nails and the you got your self a ramp.



©all rights to zubin copyright 2001